![]() ![]() Then there will eventually be a parameterD for the type of system or shutdown method if I can add values to the wake_on_lan without it complaining it’s not valid. Enable or Disable Wake on LAN (WOL) for a Network Adapter in Device Manager You must be signed in as an administrator to do this option. ParameterC is the password of parameterB user ![]() ParameterB is the username with ability to shutdown the system The best I’ve been able to accomplish so far is by going to the Control Panel, System, Device Manager, and then to Ralink RT5390 802.11 b/g/n WiFi Adapter Properties, then selecting the Power Management tab and clearing the check mark from the Allow this device to wake the computer. shutdown.sh -a parameterA -b parameterB -c parameterC So for me I have a shell script that takes three parameters right now and is called like: So obviously I need “host” or IP but also want to be able to define username and password and also the type of computer like “Windows7” or “Windows10” or “Mac” or “Linux” or whatever that will trigger different shutdown options in the same script.Ĭan you pass parameters like host to the script in the turn_off: area? Hate to create hard coded shell commands for every one of them. Microsoft DHCP reports MAC addresses of all PCs regardless of their current state (turned on or off), so if you have configured the program to use Microsoft DHCP, you can execute Wake-on-LAN operations immediately for any set of remote PCs, including collections and dynamic groups.Are you able to add to wake_on_lan your own additional parameters? I am working on a custom linux script for shutting down different kinds of computers and want to pass parameters to it that aren’t in the manual. It is preferable to extract MAC addresses from Microsoft DHCP, because in this case the program can get MAC addresses of all the PCs in your network automatically. Switch to the All Machines view to make sure that all the PCs have reported their MAC entries Pic 1. Once DHCP is configured, it will be able report MAC addresses during Retrieve MAC Address operations.īefore executing a Wake-on-LAN operation, make sure that the program knows MAC addresses of the remote PCs. Open the MAC Addresses Scan page of the program preferences to enable and check the DHCP servers configuration. If you use Microsoft DHCP in your network, you can extract MAC addresses for all the network computers.Switch to the All Machines view to see the PCs from which a MAC address has not been extracted and run Retrieve MAC Address. If a PC was turned off, you can run the Retrieve MAC Address operation to get the MAC addresses. Note that for extracting a MAC address, a remote PC should be turned on during the network enumeration. Check the Execution Results view after the network enumeration to make sure that MAC addresses of the network PCs have been detected successfully. MAC addresses for remote PCs are detected automatically during the network enumeration.The program can detect MAC addresses in multiple ways: In addition, to use Wake-on-LAN, the program should know the MAC addresses of remote PCs to generate individual WOL packets for them. ![]() You can find detailed instructions for enabling Wake-on-LAN in the Configuring Machines' hardware for Wake-on-LAN chapter.
0 Comments
Leave a Reply. |